Thermoline
Copper Pipes & Tubes / Coil
Thermoline Pipes are proud of ability to supply a wide size rang1e for refri91eration and air conditioning system. These copper tubes are supphed in both hard drawn su-aigth Ieng ht and annealed coils, after meticulous cleaning, dehydrating and capping, to ensur,e that the internal cleanliness standards are fullly met.
Standard Export Lengths
Manufacturing Standards
European Standard BS EN 1057
(Formerly known as BS 2871 PART-1)
It is applicable to seamless round copper tubes having outside diameter from 6nm up to and including 267 mm for:
- Distributing networks for hot water and cold water.
- Hot water heating systems, including underfloor heating systems ..
- Domestic gas and liquid fuel distribution ..
- Waste water sanitation.
- Industrial gases.
It is also appllicable to seamless round copper tubes intended to be pre-insulated before use for any of the above purpose.
Composition
The composition sha!II conform to the following irequirements:
Cu+ Ag: min. 99,90%
0,0 l 5% f P :S 0,040%
This copper grade is designated either Cu-DHP or CW024A.
Cu+ Ag: min. 99,90%
0,0 l 5% f P :S 0,040%
This copper grade is designated either Cu-DHP or CW024A.
Mechanical Properties
NOTE:
1. Hardness figures in partentheses are not requirements of this standard but are given for guidance purposes only.
2. 1 Mpa is equivalent to 1 N/mm2.
1. Hardness figures in partentheses are not requirements of this standard but are given for guidance purposes only.
2. 1 Mpa is equivalent to 1 N/mm2.
Project References
